Non-Pilot Arc Torch Portable Electric Plasma Cutter 110/220V with Attached US Plug

  

Non-Pilot Arc Torch Portable Electric Plasma Cutter 110/220V w/ Attached US Plug. NEW Plasma Cutter 50AMP DC Inverter Dual Voltage 110V/220V. The plasma cutter was beautifully designed to cut stainless steel, alloy steel, mild steel, sheet metal, copper aluminum as well as other metal materials. Plasma Cutter 50AMP DC Inverter Dual Voltage 110V/220V. Torch Design Provides a Sure, Comfortable Grip Made from Heat and Impact Resistant Material.

Cut Up to 1/2 Inch Thick Steel with the High Performance Cutting Torch. Non-Pilot Arc Torch Provides a Longer Life for Consumables. High Cutting Performance Due to the Advanced Inverter Technology.

Input Voltage: 110-220V, 1-PH, 50/60Hz Dual Voltage. 8mm Thick Steel (Optimal Cut). 10mm Thick Steel (Maximum Cut). Air Supply: Clean, Dry, Oil-Free Air. Material: Stainless Steel, Mild Steel, Aluminum, etc.

Important Please Read: You will need to have your own air supply from an air compressor. Plasma cutter includes a standard US 110V plug, to reach the 50A cut specs you will need to connect a 220V plug. 1x Plasma Cutter Power Supply.

This product may contain chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings. They do not sponsor or endorse our materials.

This Product is intended for off-road use only. We cannot be held liable if the product is used in conjunction with any vehicle on U.

Or Canadian roads or highways or in any other jurisdiction where the Product would not meet safety or emission standards, as specified by that jurisdiction.