Non-Touch Pilot Arc Air Power Plasma Cutter 1/2 Inch Clean Cut

  
[NON-TOUCH PILOT ARC] Efficiently cuts though rough, painted, and rusty surfaces and produces minimal slag. Pilot arc technology allows you to cut without touching the tip to the metal. Better cutting quality and longer consumable life. [BUILT-IN POST FLOW] When you stop cutting, the air runs on for a minute to cool the consumable of the plasma cutter torch. This will extend consumable life.

[POWERFUL CUTTING ABILITY] 10-55 A DC output, 1/2"ideal clean cut and 3/4"maximum severance cut under 220/240V, 60% Duty Cycle. Uses non-hazardous compressed air to cut stainless steel, alloy steel, mild steel, copper, and aluminum.

[LIGHTWEIGHT AND PORTABLE] Allows for connection to 110 or 220 volt receptacles without tools, Portable in the shop or at the job site-at 13 l b, the shoulder strap allows the end user to easily move from location to location. [ADDED SAFETY] Certificated by ETL, Automatic compensation for voltage fluctuation, over current protection, over load protection, temperature control. Note:Due to the inner structure, the pressure gauge may only read about 30psi, which is the normal phenomenom and it do not affect the whole operation. Allows for connection to 110- or 220-volt receptacles without tools. Portable in the shop or at the job site-at 13 lb the shoulder strap allows the end user to easily move from location to location.

Pilot ARC Start lets you start the arc before contacting the work piece. This give you bettet control of the torch, especially on materials with uneven or curved sufaces. Max Rated Clean Cut Thickness: 1/2.

Compact plasma cutter uses non-hazardous compressed air to cut stainless steel, alloy steel, mild steel, copper and aluminum.